Meters are suitable for pipe sizes ranging from 2½ to
72 inches. Patented Dual Turbine Meters provide partial
compensation for irregular flow conditions caused by
inadequate straight pipe runs.
traceable factory calibration performed on every
meter, within ±0.5% of reading accuracy at the
calibrated (typical) flow velocity and within ±1-2% of
reading over a 50:1 flow range. ONICON's price vs.
performance is unmatched.
Unequaled Operating Range
Provides repeatable flow data over a
175:1 turndown from 0.17 to 30 ft/s.
impedance sensing method, low mass non-metallic
turbines with sapphire jewel bearings and tungsten
carbide shafts provide a mechanical system that
virtually does not wear.
Hot Tap Insertion Design
HOT-TAP design is standard for all insertion meters
and allows installation and removal without system
shutdown. Meters can be removed and reinserted by hand
without special tools.
enclosure includes integral conditioned output
circuitry for ease of installation. Analog output
models include both 4-20 mA and 0-10 VDC signals.
Isolated-analog, dry contact switch and frequency
outputs are also available.
ONICON F-1200 Series
Insertion type flow meters are designed to work in
pipe sizes ranging from 2½ to 72 inches in diameter. The
F-1200 Series flow meters employ our patented dual
turbine technology to deliver highly accurate flow
data even when installed in straight pipe runs that
are too short to establish a fully developed flow
profile. The F-1200 Series meters are ideal for
central plant applications where short pipe runs are
Typical uses for the F-1200 Series Meter
include: chilled water, hot water, condenser water,
domestic water, process cooling, steam condensate and
F-1200 Series Product Selection Guide
|Dual Turbine Insertion Flow Meter with frequency
output - provides a high-resolution
frequency output for connection to an ONICON
Display or BTU Meter.
Turbine Insertion Flow Meter with analog
output - provides 4-20 mA & 0-10 V
Turbine Insertion Flow Meter with isolated
analog output - provides isolated
mA & 0-10 V analog outputs.
Turbine Insertion Flow Meter with divided output
- provides a conditioned binary/digital
output signal corresponding to flow
Turbine Insertion Flow Meter with scaled output
- provides a scaled binary/digital output
for flow totalization.
|Totalizing Flow Display with network interface designed for use with any ONICON flow meter.
Module Series for F-1200 Series Flow
Installation Kit Overview for Insertion Turbine Flow Meters
Information for ONICON Insertion